Dead Rising 2 [BLUS30439]

Dead Rising 2 attempts to go to the title screen and loads the copyright text for the game, but then stops.

Code:

E {PPU[0x1000000] Thread (main_thread) [0x010ea020]} cellGcmSys: cellGcmSetTile: bad compression mode! (7)
E {PPU[0x1000000] Thread (main_thread) [0x010ea020]} cellGcmSys: cellGcmSetTile: bad compression mode! (11)
U {PPU[0x1000000] Thread (main_thread) [0x010e9f20]} cellGcmSys TODO: cellGcmSetZcull(index=0, offset=0xb2c0000, width=1024, height=576, cullStart=0x0, zFormat=0x2, aaFormat=0x3, zCullDir=0x0, zCullFormat=0x1, sFunc=0x1, sRef=0x80, sMask=0xff)
E {PPU[0x1000001] Thread (FileOp) [0x010e9b60]} sys_fs: sys_fs_stat(“/dev_bdvd/PS3_GAME/USRDIR/data/serial.bin”) failed: not found
E {PPU[0x1000001] Thread (FileOp) [0x010e9b60]} 'cellFsStat' failed with 0x80010006 : CELL_ENOENT
E {PPU[0x1000001] Thread (FileOp) [0x010e9b60]} sys_fs: sys_fs_stat(“/dev_bdvd/PS3_GAME/USRDIR/data/capcom.txt”) failed: not found
E {PPU[0x1000001] Thread (FileOp) [0x010e9b60]} 'cellFsStat' failed with 0x80010006 : CELL_ENOENT

RPCS3 v0.0.36-17740-37dbd776 Alpha | master | FW 4.92

Windows 10
i7-10870H
3070 Laptop GPU
32 GB 2933 MHz RAM

I followed the recommended settings in the wiki.
It makes it in game, however the framerate is consistently around 18-22 fps. There are moments where it gets close to 30 fps, but those are mainly in cutscenes or really quiet areas.
There was some graphical glitches when the tutorial windows showed up, but I wasn't able to capture that.